The Top 5 Most Common Problems of Garage Door Openers

By: Richard Palmer Click author's name for more of his/her articles

Back in the days when garage doors were simply made to keep your car under a roof they were pretty much trouble free. It was only when they enclosed automatic opening features that everything started to become difficult. Here are the most common problems of garage door openers. It is best to examine the manual or approach a professional for adjustments and repairs that aren’t self-evident.

If your garage door starts opening by itself, try to remember if you changed the batteries lately. If you did, then take try nudging the battery connectors after taking the battery out because they can move a bit and press against the pad in such a way that the garage door trigger is set off.

Garage door opener only opening part of the way: It is most likely a sign of wearing parts. The springs found on each side of the door can lose tension over time and eventually stops helping the opener with the maneuvering of the door. This can be brought in too much weight to the opener and it can jam or mistake the weight as a sign the door is closed. The motor and gears are very puny and sometimes even made of plastic, so it will definitely wear out as the opener lugs the door up and down repeatedly year after year. Depose the gunk and grease the gear mechanisms. You can fix it yourself, but a good garage door specialist is always worth bringing in.

Garage Door Opener Automatically Reverses: There are 2 sensors that are located on each side of the interior garage door frame. When something passes through them, they send a signal to the motor unit, which will then refuse to close the door. It takes a few seconds to process this instance so the door moves some of the way and then reverses. Normally the area around the bottom of the garage door is dirty and dusty and removes anything that blocks them and the best solution is to lightly clean the lens of the sensors.

Garage Door Opener Motor Runs: There might be a problem with the chain section or opener itself. Disengage the garage door by pulling on the release cable halfway between the garage door and the opener, making the door come down. To see if it still works manually close or open the garage door. They are normally put under a lot of strain every time the door is closed or opened so click the opener to see if the gear assembly is broken. You can have the opener system replaced or fixed, but when the new gears may be so strong that they’ll immediately overwhelm the small motor and burn it out. It is advised to just buy a new garage door opener to avoid this problem.

When a Torsion Spring Snaps: A metal spring that has corroded would mean that the other springs are bound to break as well, and therefore need to be replaced. Call a repairman immediately to replace the springs. Always keep in mind that an ounce of prevention is worth a pound of cure. You can never go wrong with the services of a professional so you better rely on them.

Article Source: ABC Article Directory

About The Author: Richard Palmer is a specialist in repairing and installing garage doors . His 10 years of experienced has developed his outstanding skill and knowledge. Visit www.usgaragedoors.com to get the best services on your garage doors.